Description: Description: C:\DataPro_Install_V5\ReadMe\bannerlogo.jpg

 

Contents

Description: Description: C:\DataPro_Install_V5\ReadMe\BULLET.GIF

Introduction

Description: Description: C:\DataPro_Install_V5\ReadMe\BULLET.GIF

System Requirements

Description: Description: C:\DataPro_Install_V5\ReadMe\BULLET.GIF

Installation

Description: Description: C:\DataPro_Install_V5\ReadMe\printpage.gif

Description: Description: C:\DataPro_Install_V5\ReadMe\LOGO-WHITE.jpg

DataPro Version 6.0

January, 2013

Introduction

DataPro is a suite of software products designed to support Stack Data Logging Systems.

The suite comprises:

Application

Description

Stack DataPro

Data acquisition and analysis tool

DataPro Designer

System configuration designer and programmer

RunManager

An Explorer-style application for run data management

TeleMonitor

Telemetry monitor for use with radio modems

Gateway Template Editor

Creates and edits Stack ECU Gateway Template files for Designer.



System Requirements

The recommended system configuration for DataPro is provided in the table below:

Component

Recommended Requirement

Processor

Athlon® 64 - class PC (2.4 GHz or higher recommended)

RAM

2 GB or greater

Hard Disk

120 GB or greater (SCSI drive preferable for video synchronisation)

Display

Designed for SXGA at 1280 x 1024 resolution or higher

Operating System

Microsoft Windows 7

Browser

Microsoft Internet Explorer 9 or higher

Privileges

Administrative Privileges on the system for installation only

Mouse

Microsoft IntelliMouse or other compatible pointing device

USB Port

USB2.0 or higher

Description: Description: C:\DataPro_Install_V5\ReadMe\returntotop.gif top

 

Installation

IMPORTANT: The software products Stack DataPro and/or DataPro Designer must be installed before you plug the CAN USB Network Interface into your USB port for the first time!

1.     Insert the Stack DataPro CD-ROM into your CD-ROM drive.

2.     If you have AutoRun enabled the Setup program should start automatically.

3.     If AutoRun has been disabled, use Windows Explorer to go to the root folder of the installation CD-ROM and run the Setup program.

4.     Follow the instructions in the installation wizard.

5.     Once installed, remove the CD-ROM from the drive.

6.     Plug the CAN USB Network Interface into an available USB port on your PC (Note: the jack plug does not need to be connected to your car at this time).

7.     Follow the instructions in the Found New Hardware wizard.

For more detailed information concerning both hardware and software installation please refer to the DataPro Manual which can be found on the root folder of the installation CD-ROM. Please note that you will need Adobe® Acrobat® Reader™ to view the manual, the installation program for which may be found in the Acrobat folder on the installation CD-ROM. 

Description: Description: C:\DataPro_Install_V5\ReadMe\returntotop.gif top